Image activities | ||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
Information | ||
![]() |
03_Torx Bolts.jpg | ![]() |
![]() |
JPEG | ![]() |
![]() |
Resolution: 2592×1944 | ![]() |
![]() |
File size: 2459827 bytes | ![]() |
![]() |
Date: 7/10/06 5:29 PM | ![]() |
![]() |
Flash: Flash did not fire, auto | ![]() |
![]() |
Focal length: 6.0mm | ![]() |
![]() |
Exposure time: 1/160s | ![]() |
![]() |
Aperture: 4.0 | ![]() |
![]() |
Metering mode: Center weighted average | ![]() |
![]() |
Camera: Canon | ![]() |
![]() |
Model: Canon PowerShot S2 IS | ![]() |
![]() |
Sensor type: OneChipColorArea | ![]() |
![]() |
The Torx bolts had some white corrosion products in the threads near the bolt heads. It's been cleaned away with a wire brush in this picture. Also seen in the threads was a brittle yellow substance which fell off when I cleaned the bolts. I decided this substance was a thread locking compound (which explains why the bolts had so much drag when I removed them), so used some Loctite when I re-installed the switch.